*NEW* Fenix HM65R-T V2 Headlamp* w/ FREE Helmet Mount

• Compact: 3.2" long by 1.9" wide lightweight magnesium alloy body
• 1600 Lumens max (170-meter beam)
• This Headlamp is two lights in one: White cool light for extreme distance in fair weather and a warm light for better coverage in foggy and poor conditions, each light has its own up-top switch each with 3 brightness modes
• Easy to rotate fore/aft with 60 degrees of tilt, so you can fine tune exactly where you want your light
• Fenix 18650 3400mAH Rechargeable Li-ion Battery is included (optional Combo Deal includes another Battery for those that want to ride all night long), also accepts two CR123A batteries
• Includes a USB Micro C charging cord for a fast recharge and thru charging during use
• Headband has a Boa-type dial to cinch it easily with one hand
• Your choice of Headlamp Helmet Mount: chose the mount with Headband Keepers if you want to use lamp with the headband or choose the Helmet Mount with Shock Cord clips if you want a light dedicated to the helmet without using the headband
• Waterproof, Impact Resistant, comes w/ 5-year warranty
• 152 grams with battery, headband and mount kit, so it won't weigh down your helmet
• Risk-Free Purchase: if you're not satisfied, we'll send you a return label and exchange it for free! 

*Please note: Due to Regulations, we can only ship these Lights to USA addresses (please do not order these for international shipping)

Instructions for Mounting Keepers to Helmet:

1. Find a surface on the helmet above the ear for the side Dual Lock tape bases
2. Find a single spot in front of the helmet for the front Dual Lock base that is positioned directly behind the Headlamp (depending on the venting of your helmet, you may need to place two Dual Lock bases at the front that go to each side of the Headlamp) Note: The HM65R-T is a little heavier than the HM50R, so we suggest placing it midway back between the front and top of the helmet so that it balances well on your helmet.
3. Optional: Find a spot at the back of the helmet for the back Dual Lock base
   
4. Peel and stick Dual Lock bases to the helmet on those spots
5. Snap on the Headband Keepers onto their Dual Lock bases
6. Fully loosen headband and place it into the Keepers and tighten if necessary

Instructions for Fenix Helmet Mount with Shock Cords:

1. Find a spot at the top of helmet a slightly forward of center where headlamp feels balanced
2. Wrap Shock Cord hooks thru vents in helmet around to the other side of the mount and clip them on to the loop in the shock cord. Note: may be more comfortable to route the Shock Cords so they go under the helmet liner
3. Pull the ends of the Shock Cord tight and then tuck them into themselves for a clean look
   
4. Remove headband from your Fenix headlamp and slide the lamp downward in the mount until in snaps into place and you're ready to ride